LogoV380 Pro Docs
LogoV380 Pro Docs
HomepageDocumentation
Device Startup
Network Setting
Network Configuration
How to connect the camera to the router when camera prompts "Please scan the QR code on the camera" (QR code connection)How to connect the camera to the router when camera prompts "Please scan the QR code on the camera" (AP hotspot connection)How to configure wireless camera network (Android users)How to configure wireless camera network (iOS users)How to connect the camera via BluetoothHow to connect the device if the QR code is damaged or scanning failsHow to connect the camera to the router without QR codeDuring the configuration process, the device has connected, but the APP doesn't prompt "Completed"What if the device fails to connect to WiFi during network configurationHow to connect a camera with a network cableHow to connect 4G cameraWhat if 4G camera fails to connectWhat to do if the SIM card can't be usedHow to connect WiFi kitHow to connect the device under the AP station (connecting without router)Why can't camera connect to 5G frequency WiFiHow to connect solar-powered WiFi cameraHow to judge the connection status of solar-powered WiFi cameraHow to connect solar-powered 4G cameraSolar-powered 4G camera offline
Networking Settings
Network Connection
Software Setting
Real-time Preview
Record & Replay
Cloud Service
Alarm Setting
4G & Solar-powered
Other Questions
Network SettingNetwork Configuration

How to configure wireless camera network (Android users)

Guide for Android users to configure wireless camera network

Preparation before configuration

  1. Power on the camera, press and hold the reset button for a few seconds, and then hear the camera voice prompts "Restore factory default settings - access point preparing - access point ready". When the (MV+ID/HSC+ID) hotspot signal is found in the WiFi list of the mobile phone, it means that the device is in the waiting configuration state

Note: The voice prompts may be different, please refer to the actual prompts of the camera

Related link: How does the camera establish a hotspot mode

Configuration steps

  1. Click the "+" button in the upper right corner of the device list, select [Add Camera]

  2. Scan the QR code on the device or swipe up the bottom and select [Wi-Fi Camera] - [AP hotspot connection], and follow the system prompts to continue operation

  3. Select the WiFi that the device needs to configure, enter the WiFi password, and click [Confirm]

  4. Below Android 10: Select the device hotspot, and the mobile phone will automatically start network configuration after connecting to the hotspot

    Android 10 and above: Click [Connect AP spot] or enter the mobile phone system [Settings], select [WLAN], connect to the device hotspot (MV+ID/HSC+ID), and the device will automatically connect to WiFi after returning to the app

  5. The camera's voice prompts "WiFi connecting - WiFi connected" to indicate that the configuration is successful, and the APP prompts "Completed"

Capabilities are adjusted with system versions. Actual usage prevails.

How to connect the camera to the router when camera prompts "Please scan the QR code on the camera" (AP hotspot connection)

Guide to configure camera network via AP hotspot connection

How to configure wireless camera network (iOS users)

Guide for iOS users to configure wireless camera network

Table of Contents

Preparation before configuration
Configuration steps